以太网端口镜像和链路聚合配置.pptVIP

以太网端口镜像和链路聚合配置 ISSUE 1.0 参考资料 S3900交换机操作手册 S3900交换机命令手册 学习完此课程，您将会： 掌握以太网交换机端口镜像的配置方法 掌握以太网交换机链路聚合的配置方法 基于端口的镜像配置 进入以太网端口视图 interface { interface-type interface-number | interface-name } 配置当前端口为监控端口 monitor-port 配置当前端口为被监控端口 mirroring-port { inbound | outbound | both } 显示端口镜像参数设置 display mirror 基于流的镜像配置 进入以太网端口视图 interface { interface-type interface-number | interface-name } 配置当前端口为监控端口 monitor-port 配置流镜像 mirrored-to { inbound | outbound } { user-group acl-number [ rule rule ] | ip-group acl-number [ rule rule [ link-group acl-number rule rule ] ] | link-group acl-number [ rule rule ] } { cpu | monitor-interface } 链路聚合配置命令 进入以太网端口视图 interface { interface-type interface-number | interface-name } 使能端口LACP协议 lacp enable 链路聚合配置命令 系统视图下创建汇聚组 link-aggregation group agg-id mode { manual | static } 进入以太网端口视图 interface { interface-type interface-number | interface-name } 将以太网端口加入汇聚组 port link-aggregation group agg-id 链路聚合配置命令 系统视图下配置系统优先级 lacp system-priority system-priority-value 进入以太网端口视图 interface { interface-type interface-number | interface-name } 配置端口优先级 lacp port-priority port-priority-value 链路聚合显示和调试 显示所有汇聚组的摘要信息 display link-aggregation summary 显示指定汇聚组的详细信息 display link-aggregation verbose [ agg-id ] 清除端口的LACP统计信息 reset lacp statistics [ interface { interface-type interface-number | interface-name } [ to { interface-type interface-num | interface-name } ] ] 链路聚合显示和调试 打开LACP报文的调试开关 debugging lacp packet [ interface { interface-type interface-number | interface-name } [ to { interface-type interface-num | interface-name } ] ] 打开端口汇聚运行错误的调试开关 debugging link-aggregation error 链路聚合配置举例 链路聚合配置举例 [SwitchA] link-aggregation group 1 mode manual [SwitchA] interface ethernet1/0/1 [SwitchA-Ethernet1/0/1] port link-aggregation group 1 [SwitchA-Ethernet1/0/1] interface ethernet1/0/2 [SwitchA-Ethernet1/0/2] port link-aggregation group 1 [SwitchA-Ethernet1/0/2] interface ethernet1/0/3 [SwitchA-Ethernet1/0/3] port link-aggregation group 1 链路聚合配置举例 [Swit