dek高级培训资料.pptVIP

* Instructor Notes This will save certain information to printer configuration file (config.cfg) to enable the camera system to accurately align the stencil to the board fiducials * Instructor Notes It is important that the students watch what is happening and make sure that the centre of the located fiducial is accurately marked for each step of the procedure. * Instructor Notes We know that we have moved the exact distance because we know the pitch of the actuator lead screw and how far it moves for each step of the stepper motor. 1 step = 3.41 microns Note: this is why it is only possible to insert offsets into the product file in increments of 4 microns * Instructor Notes This process is repeated around all 25 fiducial locations. The theta cal is carried out on 3 fiducials Using +2mm in x rear, -2mm in x fwd All this data is stored by the software * Objective 21 You will require an empty and full paste cassette in order to calibrate the empty and full levels. If you do not have these then the principle can be demonstrated with objects of suitable thickness (ie small spanner = empty, screwdriver handle = full) * Describe difference with analogue and digital paste level sensors * See KB1110 for paste dispenser design improvements. Home sensor does not display in diagnostics (defect PCRS191). Belt tension 55-65hz either side of clamp * Objective 22 * Screen change and drip tray are considered part of the chase (!). When ordering a machine via the DOES system, or upgrading USC sizes in the field the following information should be checked to ensure USC to ASM clearance. For 520 mm USC Minimum ASM setting 600mm For 400 mm USC Minimum ASM setting 485mm For 300 mm USC Minimum ASM setting 385mm * Objective 23 When the chase rail is replaced check that the stencil is still level within the ASM and check that the distance from rail to table is even in all four corners (Raise table to print height and use a depth mic.) This should really be done properly