加层建筑及大跨度屋盖静力风载数值模拟研究-防灾减灾工程及防护工程专业论文.docxVIP

郯州大学硕上学位论文ABSTRACT 郯州大学硕上学位论文 ABSTRACT The structure with steel construction light-duty roofing system is quite different with other roofing system on anti-windy loading，this kind of gmctnre is strongly affected by partial windy loading．Many investigation result about windstorm shows，the damage sample of large modem s[1mcture by windstorm is not eonlnlon，but the windy storm damage sample of part—superficial spalling and part roofing tilting are commonly occur．Especially the windstorm and typhoon attack the whole roofing to broken，SO We need pay more attention tO the anti—windy system of steel construction light—duty roofing，and it also bring new subject to anti-windy design calculation． For when the wind flew through large—span roofing structure，it will create complex airflow breakaway and reattachment，the wind pressure distribution of large-span roofing structure is very sophisticated，and the alteration gradient of wind pressure are very large from leading to the end part，so a single physical coefficient reflect difficultly the wind loading of roofing．But the numerical simulation of CFD caIl accurately simulate every kind ofwind pressure distribution ofroofing system，and bring the important parameters that the anti—windy calculations of long—span roofing needed，and provide significant technical measures to the anti-windy design． In actual production and living，some structure built have not meet the challenge，for the land limited and so on，it cannot build new StTUcture，some proprietor build another structure on the existing building．To decrease the disadvantage factor to the existing buildings，the best choice is steel construction light-duty roofing system．The added-layer is up the fifth and sixth floor，but the applicable codes and standards had not explanation tO this kind of wind—loading，the design organization and the professional steel construction company calculated wind loading by increasing the calculation height from the existing structures．But it does not m