下压量对微型燃料电池双极板成形弹的影响.docVIP

下压量对微型燃料电池双极板成形回弹的影响 XX （江苏大学机械工程学院 学号 班级） 摘要：双极板是微型燃料电池关键部件之一，微尺度下的高精度极板流道给其成形方法带来了难度，本文针对双极板的特点提出了累积成形方法。在介绍微累积成形工作原理的基础上搭建了相应的实验装置，选取0.165mm和0.27mm板厚的实际成形区域为7mm×7mm铝合金板作为双极板毛坯，进行了累积成形试验，分析其成形规律，研究了不同下压量对成形深度和回弹率的影响。结果显示不同下压量时板料成形深度-位移曲线在成形起始点和终点处成形深度比较大，向中间区域靠近时成形深度逐渐变小，而且成形深度随着垂直下压量的增大而增大，曲线也随着下压量的增大而逐渐趋于平缓；不同下压量时成形深度回弹率-位移的变化曲线与成形深度-位移曲线的趋势相反，在成形起点和终点处成形深度回弹率较小，中间区域回弹较大，并且观察图形，可以发现当垂直下压量增大时，板料的回弹率越大而且回弹率曲线变化越平缓。 关键词：微型燃料电池；双极板；回弹；累积成形；成形规律； The study of accumulate forming mechanism in micro fuel cell bipolar plate XXX (Jiangsu University, ......) Abstract: The bipolar plate is a key component of micro fuel cell. It is difficult to form the high precision flow channel of bipolar plate under the micro scale. In this paper, we present the method of accumulative forming for the characteristics of bipolar plate. On the basis of introducing the principle of micro-accumulation forming, we set up the corresponding experimental apparatus, selecting 7mm×7mm×0.165mm and 7mm×7mm×0.27mm aluminum plate as the bipolar plate blanks to do the accumulated forming test. We analyze the shaping law and the influence of different amount of underdraught on the forming depth and resilience rate. The results show that when the plates has different underdraught, the forming depth-the displacement curve represents that the forming depth is bigger at starting point and end point, forming depth is becoming smaller when close to middle area, and forming depth also increases along with the amount of vertical underdraught, the curves also gradually become gently; at the same time, the trend of resilience rate-the displacement curve is opposite to the forming depth-the displacement curve, resilience rate is smaller at starting point and end point as the middle area resilience rate is bigger. We can also find that the resilience rate is bigger and the change of the resilience rate curve is gentle when the vertical underdraught increases. Keywords: Micro fuel cell; bipolar plate; accumulat