黄河三角洲的泥沙冲淤规律与数值模拟-环境工程专业论文.docxVIP

  • 7
  • 0
  • 约4.97万字
  • 约 76页
  • 2019-04-26 发布于上海
  • 举报

黄河三角洲的泥沙冲淤规律与数值模拟-环境工程专业论文.docx

y《口5980摘 y《口5980 摘 要 本文采用分形分维方法和数值模拟方法对现代黄河三角洲的水下 地形形态、泥沙输运和冲淤的变化规律进行了系统的研究和探讨。f对此, 首先依据黄河三角洲多年的实测水深资料,并利用分形分维方法,、对黄 河三角洲水下地形的分维值进行了计算,进而从时间、空问以及与黄河 来水来沙条件的关系三个角度比较和分析了这些分维值的变化特征,并 据此从水下地形形态变化的角度探讨了黄河三角洲发育演变的时空变 化规律。在此基础上,进一步建立了二维潮流输沙模型、底床变形模型 以及长周期泥沙动床冲淤模型,并利用这些模型和动边界处理技术对黄 河三角洲的泥沙输运和冲淤问题进行了数值模拟。同时,还利用这些数 值模型对黄河三角洲的冲淤变化对不同水沙条件和河口走向的响应进 行了数值模拟和分析研究。研究结果表明,分维值能很好地反映黄河三 角洲水下地形的形态复杂程度和冲淤变化的特征,而本文提出的地形与 潮流、泥沙的二维耦合模型也可较好地模拟黄河三角洲的冲淤演变规 一 律。j / 7通过黄河三角洲冲淤演变的分形分维和数值模拟研究,初步得出以 下结论:1)水下地形的分维特征能很好地反映其复杂程度。分维值的 大小及时空变化规律说明了改道初期地形改造强烈,随着进一步冲淤, 分维值降低;而且由于黄河入海泥沙的直接影响,口门淤积区比北部冲 刷区的地形改造更为强烈,分维值高且变幅大。2)泥沙冲淤数值模拟 结果不仅表明二维潮流输沙模型以及动床淤积模型在黄河三角洲是可 行的,而且表明在长周期冲淤模拟中水深的变化是不容忽略的;整个三 角洲海域的冲淤格局是现行口门淤积和废弃口门冲刷;并且很大程度上 受到入海泥沙粒度、来水来沙量以及河口走向的影响。 、j| 。7 i 关键词:黄河三角洲。分维特征泥沙冲淤。数值模拟u AbstractBy Abstract By using the fractal geometry method and numerical modeling,the modalities of underwater topography and the sediment transport and deposition of the Yellow River delta are studied in this paper.Firstly,the calculational method of fractal dimension iS applied to calculate the fractal dimension of the underwater topography according to the real investigated data And from three points of view:time,space and the relationship between flow—sand condition and the fractal dimension.the fractal characteristics are compared and analyzed,and the spatio—temporal law of growth and evolvement of the Yellow River delta is discussed.Then,Oil the basis of the above studies,2-D models of sediment transport by tidal current, sea·-bed transmogrification and sea--bed coupling with sediment and tidal current are founded and applied in the whole sea area of the Yellow River delta.The law of erosion and deposition of sediment is simulated in large—scale and in long—Fun,and some conclusions have been obtained. At first,the fractal dimension reflects the complexity of topography well,whose amount and spatio—temporal variation indicate the law of erosion and deposition.The result of the simulation indicates that the 2。D models are

您可能关注的文档

文档评论(0)

1亿VIP精品文档

相关文档