Brocade SAN交换机操作手册及常用命令.doc

Brocade SAN交换机常用命令 使用电脑连接管理网口，默认IP地址为：7，掩码： 默认用户名：admin，默认密码password 1. switchStatusShow 查看交换机的总体健康状态 switch:admin switchstatusshow Switch Health Report Switch Name: SWFCR IP address: 76 SwitchState: MARGINAL Duration: 863:23 Power supplies monitor MARGINAL Temperatures monitor HEALTHY Fans monitor HEALTHY WWN servers monitor HEALTHY Standby CP monitor HEALTHY Blades monitor HEALTHY Flash monitor HEALTHY Marginal ports monitor HEALTHY Faulty ports monitor HEALTHY Missing SFPs monitor HEALTHY All ports are healthy switch:admin 2. switchShow 查看交换机基本配置信息 Enter the switchShow command, which displays the following information for a switch: - switchname - The switch name. - switchtype - The switch model and firmware version numbers. - switchstate - The switch state: Online, Offline, Testing, or Faulty. - switchrole - Displays the switch role: Principal, Subordinate, or Disabled. - switchdomain - Displays the switch Domain ID. - switchid - The embedded port D_ID of the switch. - switchwwn - The switch World Wide Name. - switchbeacon - The switch beaconing state: either ON or OFF. The switchShow command also displays the following information for ports on the specified switch: - Module type - The SFP type if an SFP is present. - Port speed - The speed of the Port (1G, 2G, 4G, N1, N2, N4, or AN). The speed can be fixed, negotiated, or auto-negotiated. - Port state - The port status. - Comment - About the port. This section may be blank or display the WWN for an F_Port or an E_Port, the trunking state, or upstream or downstream status 3. portShow 查看端口状态 switch:admin switch:user portshow 0 portName: portHealth: OFFLINE Authentication: None portDisableReason: None portCFlags: 0x1 portFlags: 0x4001 PRESENT U_PORT LED portType: 4.1 portState: 2 Offline portPhys: 2 No_Module portScn: 0 port generation number: 0 portId: 010000 portIfId:portWwn: 20:00:00:60:69:00:02:53 portWwn of device(s) connected: Distance: normal portSpeed: N2Gbps LE domain: 0 Interrupts: 0 Link_f