压缩空气储罐计算书-ASMEU钢印.docVIP

DOC. NO.: CS09-001-1 REV.: 1 PAGE PAGE 1 OF 37 CALCULATION SHEET FOR COMPRESSED AIR STORAGE TANK (JOB NO.: SP09-U-001) (DRAWING NO.: SP09- 3 2 1 2010.01.14 1st 0 2009.10.31. FIRST ISSUE REVISION DATE DESCRIPTION DESIGNED by ENGINEER TECHNOLOGY DEPT. MANAGER SUZHOU PFAUDLER GLASS-LINED EQUIPMENT CO., LTD 苏州法德尔搪玻璃设备有限公司 .  TABLE OF CONTENTS 1 DESIGN DATA 3 2 THICKNESS OF CYLINDRICAL SHELL UNDER INTERAL PRESSURE 6 3 THICKNESS OF ELLIPSOIDAL HEADS, PRESSURE ON CONCAVE SIDE 8 4 THICKNESS OF NOZZLE NECK UNDER INTERNAL PRESSURE 11 5 MAX. ALLOWABLE WORKING PRESSURE 21 6 HYDROSTATIC TEST PRESSURE AND TEMPERATURE 22 7 REINFORCEMENT FOR OPENINGS 23 8 STRENGTH CALCULATIONS FOR NOZZLE ATTACHMENT WELDS FOR PRESSURE LOADING 26 9 CHECK THE ADEQUACY OF THE ATTACHMENT WELDS AT OPENINGS 27 10 CHECK FLANGE TO NOZZLE NECK WELDS 29 11 DESIGN OF SUPPORTING LEGS 30 12 THE CALCULATION OF LIFTING LUG 32 13 PRESSURE-TEMPERATURE RATING FOR ASME FLANGE 34 14 CHECK FOR POST WELD HEAT TREATMENT 35 15 EVALUATION OF IMPACT TEST REQUIREMENT 36 1. DESIGN DATA: (1) APPLICABLE CODE CUSTOMER SPECIFICATION ASME SEC.Ⅷ DIV. 1 2007 EDITION AND 2009 ADDENDA. DOC. NO. DC-09-1/Rev 0 (2) DESIGN PRESSURE INTERNAL 1.3MPa (3) DESIGN TEMPERATURE 50 (4) TYPE OF JOINTS OF CATEGORIES A AND B TYPE NO.1 (5) RADIOGRAPHY SPOT per UW-11(b) (6) JOINT EFFICIENCY SHELL: 0.85, HEAD: 0.85, SHEEL to HEAD: 0.85 (7) CORROSION ALLOWANCE 1 (8) MATERIAL SHELL HEAD :SA-516M Gr. NOZZLE: SA-106Gr.B FLANGE: SA-105 SUPPORT LEGS:20(GB/T8163-2008) SUPPORT PLATE: SA-285M LUG:SA-516M Gr. (9) MAX. ALLOWABLE STRESS AT DESIGN TEMPERATURE SA-285M Gr.C:108MPa at SA-105M: 138MPa at SA-106Gr.B: 118MPa at 50 SA-516M Gr.485: 138MPa at (10) HEAD TYPE 2:1 Standard Ellipsoidal Head (11) TANK CAPACITY 1.5 (12) SERVICE FLUID COMPRESSED AIR (no lethal) (13) MIN. SERVICE TEMPERATURE -1 (14) THE LOADING CONSIDERED IN DESIGNING SEE TABLE 1-1 (15) TANK DIMENSIONS SEE FIG. 1-1 TABLE 1-1 LO