ANSYS nCode DesignLife软件介绍 第十讲 Lecture 10 Stress-Life Fatigue – Part 2.pdfVIP

Introduction to ANSYS nCode DesignLife Customer Training Material Lecture 10: Stress-Life Fatigue – Part 2 Introduction to ANSYS nCode DesignLife Agenda Customer Training Material • Discuss multi-axial assessment • Discuss combination methods • Discuss certainty of survival • Discuss notch effects • Discuss safety factors ANSYS, Inc. Proprietary Release 14.5 © 2013 ANSYS, Inc. All rights reserved. L10-2 April 20133 Introduction to ANSYS nCode DesignLife Stress-Life Approach Customer Training Material • Stress-life (SN) fatigue assumes that fatigue damage is produced by fluctuating stresses – stresses drive fatigue – original numerical fatigue approach – based on alternating stress range and Wohler fatigue curves (S-N curves) – vast amount of industry experience – still most widely used fatigue analysis method – only applicable to elastic stresses • limited to low stress/high cycle applications • usually more than 100,000 cycles to failure for ductile metals – simple technique • often can be checked with hand calculations ANSYS, Inc. Proprietary Release 14.5 © 2013 ANSYS, Inc. All rights reserved. L10-3 April 20133 Introduction to ANSYS nCode DesignLife Multi-Axial Stress State Customer Training Material • Test data used to create material S-N curve