基于nRF24l01的无线音乐播放器设计毕业设计(论文).doc

温州大学瓯江学院本科毕业论文 PAGE II 基于nRF24l01的无线音乐播放器设计 本科毕业设计（论文） 题 目：基于nRF24l01的无线音乐播放器设计 本科毕业论文 摘　要 本文介绍了一种基于nRF24l01的无线音乐播放器设计方案。本设计方案结合了单片机技术和无线通信技术，设计的电路以单片机和无线通信模块为核心，并辅以外围电路。其工作过程是按键选择后，通过无线模块发射相应的数据，由另一无线模块接收的数据后播放不同的音乐。该系统实现了无线控制音乐播放器的歌曲播放选择和歌曲名的显示。本系统的优点是电路简单，性能可靠，实时性好，操作简单，编程容易等。 关键词：单片机；无线模块nRF24l01；模拟SPI PAGE III 本科毕业论文 Abstract This article introduced one kind based on the nRF24l01 wireless music player design proposal. The design proposal unified the monolithic integrated circuit technology and the wireless communication technology, the design electric circuit take the monolithic integrated circuit and the wireless communication module as a core, and auxiliary by peripheral circuit. After its work process is the pressed key choice, through wireless module launch corresponding data, after another wireless module receive data broadcasts the different music. This system has realized the wireless control music player song broadcast choice and a song demonstration. This systems merit is the electric circuit is simple, the perform reliably, timeliness is good, simplicity of operator, programming easy and so on Key Words：single chip microcomputer; wireless module nRF24l01；simulation SPI 本科毕业论文 23 - 目　　录 TOC \o 1-2 \t 标题 3,2 \h \u #define uint unsigned int #define uchar unsigned char #define TX_ADR_WIDTH 5 // 5 字节 TX(RX) 地址宽度 #define TX_PLOAD_WIDTH 1 // 1字节发送数据宽度 uchar const TX_ADDRESS[TX_ADR_WIDTH] = {0x34,0x43,0x10,0x10,0x01}; // 定义一个静态发送地址 TX_address uchar rx_buf[TX_PLOAD_WIDTH]; uchar tx_buf[TX_PLOAD_WIDTH]={0x00}; /***************************nrf24l01管脚设置********************************/ sbit CE = P1^0; sbit SCK= P1^1; sbit MISO= P1^2; sbit IRQ = P1^3; sbit MOSI= P1^4; sbit CSN= P1^5; /******************状态标志********************************/ uchar bdata sta; sbit RX_DR =sta^6; sbit TX_DS =sta^5; sbit MAX_RT =sta^4; /**************************************************/ /*功能描述 芯片使能（准备发送或接收模式）****************/ /**********************