麦克维尔PFS单螺杆机组技术手册(134A).pdf

Installation, Operation and Maintenance manual 803 C – 05/10 B Date: October 2005 Supersedes: 803 C – 04/06 A !#$% %()*+, McQuay is participating in the Eurovent Certification Programme. Product are as listed in the Eurovent Directory of Certified Products and on the web site 803 C – 05/ 10 B – pag. 2/30 Introduction General description McQuay PFS “B” chillers are completely assembled and factory tested before shipment. Each unit with 1 circuit has one compressor connected to one evaporator and one condenser. The units with 2 circuits are equipped with 2 compressors operating in parallel on a single evaporator and condenser. The chillers use refrigerant R-134a to reduce the size and weight of the package compared to negative pressure refrigerants, and since R-134a operates at a positive pressure over the entire operation range, no purge system is required. The controls are pre-wired, adjusted and tested. Only normal field connections such as piping, electrical and interlocks, etc. are required, thereby simplifying installation and increasing reliability. Most necessary equipment protection and operating controls are factory installed in the control panel. The manual contents are applicable to all models of PFS “B” series unless specifically referenced otherwise. Application Units must be initially started at the job site by a factory trained McQuay service technician. Failure to follow this startup procedure can affect the equipment warranty. The standard limited warranty on this equipment covers parts that prove defective in material or workmanship. Warranty does not cover materials that are subject to natural consumption. Cooling towers used with