CTL-OP-热电偶.pdfVIP

CTL CTL-OP 108 OPERATIONAL PROCEDURE Laboratory Procedure for Preparation, Attachment, Extension and Use of Thermocouples CTL-OP 108 – Ed.1, 2004-03-08 IECEE-CTL Secretariat, Fax: +1(919) 547-6251, e-mail: john.thompson@ Page 1 of 6 CTL CTL-OP 108 OPERATIONAL PROCEDURE Laboratory Procedure for Preparation, Attachment, Extension and Use of Thermocouples 1.0 PURPOSE This Laboratory Procedure establishes procedures for preparation, attachment, extension and use of thermocouples for temperature measurement. 2.0 SCOPE This Procedure applies to thermocouples for temperature measurement used for testing of electrical and similar products. This Procedure describes recommended practices shown by experience to be useful. This Procedure does not prohibit use of other practices that may also be valid and useful. 3.0 RESPONSIBILITY Laboratory personnel who prepare and use thermocouples are responsible to follow this procedure. 4.0 PROCEDURES 4.1 Thermocouples shall be prepared by staff trained in preparation of thermocouples. 4.2 Thermocouples are to be prepared as noted: 4.2.1 Inner insulation stripped back approximately 1.5 mm from tip. 4.2.2 Outer insulation, if any, stripped back approximately 15 mm from tip. 4.2.3 The tip is to be joined by a single point weld. Other reliable and consistent methods of joining the thermocouple wires may be used upon prior acceptance of the CTL.