DIN_976-1-2002_螺栓.第1部分_米制螺纹.pdfVIP

DEUTSCHE NORM December 2002 { Metric thread stud bolts 976-1 ICS 21.040.10; 21.060.10 Supersedes February 1995 edition. Gewindebolzen – Teil 1: Metrisches Gewinde In keeping with current practice in standards published by the International Organization for Standardization (ISO), a comma has been used throughout as the decimal marker. Foreword This standard has been prepared by Technical Committee Verbindungselemente mit Sonderformen of the Normenausschuss Mechanische Verbindungselemente (Fasteners Standards Committee). Amendments This standard differs from the February 1995 edition as follows: a) All stud bolts (irrespective of their nominal length) may be provided with either type A or type B ends. b) Property classes have been changed. c) The specifications relating to surface finish have been amended. d) Alternative marking by colour coding has been specified. e) References have been updated. Previous editions DIN 976: 1970-01, 1986-09; DIN 976-1: 1995-02. All dimensions are in millimetres. Introduction Stud bolts with metric thread are designed to perform functions similar to those of double end studs (clamping type or interference-fit type). This standard covers stud bolts with threads produced to tolerance 6g which is customary for bolt/nut assemblies