滚筒式抽油机设计_毕业论文设计.doc

本科学生毕业论文 论文题目： 滚筒式抽油机设计 学 院： 机电工程 年 级： 专 业： 机械设计制造及其自动化 姓 名： 学 号： 指导教师： 2013 年 5月 12日 PAGE PAGE I 摘要 本文通过对当前市场上的各种大小型抽油机进行市场调研之后，对其技术水平进行分析，于是根据设计题目来源提出了滚筒式抽油机的设计方案，在这设计过程中完成的主要工作有如下部分： 根据大庆石油开采公司的相关要求，分析了目前市场上多半采用游梁式抽油机和少部分先进的节能型抽油机的优缺点，提出了滚筒式抽油机的设计方案。并完成滚筒式抽油机相关参数的确定。如平衡配重、滚筒电机、导向轮、立柱、工作平台、平带等零件的选型设计和校核。部分零件利用proe软件建立了三维实体模型。 随着我国工业化程度的提高和经济的狂飙增长。各种能源问题对于我国的经济发展和国防建设来说越来越急迫，尤其石油的需求量更加迫切。我国一直在寻找新能源的同时，节约能源是目前有效的措施之一。 关键词 滚筒；滚筒电机；配重；制动器 PAGE PAGE II Abstract This article through to the current market of conducting market research aiming at pumping unit, analyzes the technical level, then according to the design of topic source cylinder pumping unit design scheme was proposed, the main work accomplished in the design process has the following parts: According to the relevant requirements of daqing oil company, analyzed the mostly USES the beam pumping unit on the market at present and the advantages and disadvantages of a small group of advanced energy-saving pumping unit, the design scheme of cylinder pumping unit is put forward. The determination of related parameters and completes the roller pumping units. Such as counterweight, roller motor, guide wheel, pillar, work platform, selection of belt and other parts design and check. Parts using proe software to establish 3 d entity model. Belting along with our country industrialization degree increase and economic growth. All kinds of energy issues for Chinas economic development and national defense construction is more and more urgent, especially oil demand is more urgent. Our country has been looking for new energy at the same time, saving energy is currently one of the effective measures. Key words drum; Drum motor; Balance weight; brake PAGE PAGE III 目录 TOC \o 1-3 \h \z \u 摘要 = 1 \* ROMAN I Abstract = 2 \* ROMAN II 第一章 前言 1 1.1课题提出的背景和意义 1 1.2抽油机分类 1 1.3本课题研究内容及现实意义 4 1.4 本章小结 5 第二章 滚筒式抽油机整体方案设计 6 2.1 滚筒式抽油机设计参数分析 6 2.2 滚筒