cisco controller 4400完全配置手册.pptVIP

* Note: All mini GBIC slots can be used simultaneously and AP are load balanced across all attached interfaces. * Note: Clear configuration allows you to remove the current configuration and return to factory defaults. This is a two-step process. First you must choose option 5 and then choose an image. * 详细解说每一项 * * Note: It is recommended to use switch web interface for all possible configurations due to the ease of use of switch web interface. Note: On line help is available in the form of a “?” which can show options or complete commands Note: Tab key can be used to complete commands when enough unique characters have been typed Note: Serial port or telnet/SSH has a default inactivity time out of 5 minutes. Logout will also close the serial port or telnet/SSH session. Linktest - If the client is a Cisco client, Cisco Airespace Controller will run the Cisco linktest program to test connectivity. If the client is not a Cisco client, sends 20 PINGs to the destination MAC address and will return relative signal strength indicator (RSSI) value. You cannot use variables for the MAC address. Logout – Exit the current command line interface session. PING – Packet Internet Groper (PING) sends 3 Internet Control Message Protocol (ICMP) requests to a specified IP address. Reset – Command to allow soft reboot of Cisco Airespace Controller. Save configuration – Data is saved to Non-volatile Random Access Memory (NVRAM) and is preserved in the event of a power cycle. * * * Note: Debug is not available in switch web interface. Note: Debug can only be output to the serial port and not a file. You can use a quality terminal emulation program for capturing to a file. * * * Transfer download is from a server to the controller. Transfer upload is from the controller to a server. To successfully upload or download a file, all required commands need to be entered serially and then the start command must be entered. Note: Transfer upload is one way to backup a configuration f