ansys培训_随机振动分析精编版.pptVIP

Workshop – 前处理-接触 The assembly to be shell meshed consists of multiple surface bodies separated by small offsets that account for the physical spacing between the neutral (axis) planes of each piece of steel. We need to use “Bonded” Contact in order to simulate the effect of welded and/or bolted assembly connectivity. Click on ConnectionsCreate Automatic Contact The Default definition is “Bonded” 6 Workshop – 前处理-网格尺寸 The assembly consists of multiple slender bodies plus a large flat Roof plate. We want to specify a relatively fine mesh size on the slender members but a larger element up top. By assigning larger elements on the large roof, we preserve CPU time and are able to use finer (usually more accurate) elements elsewhere. Change to Body Select. On the Outline Tree, RMB on the Mesh object InsertSizing (for slender bodies) In Details, Replace “Default” size with 2 (inches) RMB in Graphics Window, Select All But then hold CTRL and LMB single select on the “roof body” to unselect that part from this Size object. Apply InsertSizing (for the large “roof” body) Enter “4” for size in Details (for the large top plate). Use Single Select and LMB on the large Body. Apply Preview the mesh, MeshGenerate Mesh If desired, repeat the steps above to increase or decrease element sizes as desired to enhance the model or reduce CPU time. Larger Elements on roof 7 8,9 10 Workshop – 环境 For the lower edges of the truss, highlight the “Modal” branch in the Outline and Insert Fixed Supports. Switch to edge selection mode as necessary Reorient model as necessary throughout. an end view might be most convenient. Switch to Box Select Drag the LMB to select the edges at the bottom of the lower girders. Click “Apply” in the Details window 11 12 13 Workshop – 环境 For the PSD Base Excitation loads, at the Random Vibration Branch, InsertPSD Base Excitation In the Details of the PSD Load, change “Direction” to “Y Axis” for this particula