基于滑块面积加权平均滑坡滑面抗剪强度指标准三维反-公路交通科技.pdfVIP

28 3 Vol28 o3 2011 3 Journal ofH ighway and Transportation Research and Development M ar. 2011 : 1002- 0268 ( 2011) 03- 0001- 05 1 1 2 肖治宇, 陈昌富, 季永新 ( 1. , , 410082; 2. , 550001) : 针对滑坡二维反分析方法和利用非常严谨的精确三维方法进行反分析时的不足, 提出了基 滑块面积加权平 均的滑坡滑动面抗剪强度指标准三维反分析方法, 它以国内常用的剩余推力法为基础, 以每 个二维剖面的面积以及 相应剖面最后条块的剩余推力为参数, 从滑体整体角度考虑来反分析滑动面抗剪强度指标 c值, 此方法能够计算 出滑坡体每 个剖面的安全系数, 相对滑坡二维反分析方法更加符合工程实际情况; 相对非常严谨的精确三维方法进 行反分析时更加简单明了最后, 用王家寨滑坡检验了此方法的适用性, 并与其余的准三维分析方法的反分析结果 进行了比较结果表明, 此方法与国外同类方法的计算结果相近, 能够很好地考虑滑坡体的三维效应, 具有 一定的 推广应用价值 : 道路工程; 准三维反分析方法; 剩余推力法; 滑坡 + : U4161 4 : A A Quasi3D BackAnalysisMethod ofShearStrength Index of Landslide Based on SliderAreaW eighted Average Method 1 1 2 XIAO Zhiyu, CHE Changfu, JIYongxin ( 1. Institute ofGeotechnicalEngineering, HunanUniversity, ChangshaHunan 410082, China; 2. Guizhou ProvincialBuilding Science Testing Center, Guiyang Guizhou 550001, China) Abstract: Considering the drawbacks of both 2D and 3D back analysismethods in spite of the accuracy and being dramatically rigorous of the latter one, a quasi3D back analysis approach for shearing strength index of sliding surface of landslidewas developed by applying the slider areaweighted averagemethod. Based on the popular residual thrustmethod, using the area of each 2D profile and the residual thrust of the end slice for the corresponding profile as parameters, a back analysis of values of shearing strength index ( c and ) of sliding surface