HFSS的求解器-贾宝富-电子科大.ppt

扫频算法与求解频率的设置 HFSS的网格设置 网格设置 表面近似选项的定义 表面偏移（Surface Deviation）：表面偏移是四面体表面与真实曲线几何体表面之间的最大间隔。间隔的长度单位是画图时使用的单位。 法线偏移（Normal Deviation）：法线偏移是四面体表面的法线与真实曲线几何体表面法线之间最大的角度差。单位是度。 纵横比（Aspect Ratio）：纵横比是所选体或表面上所有四面体全部表面能够允许的最大纵横比。这一设置影响网格的质量而不是实际的网格体积或表面定位。 * * The 3D post-processor interface may look familiar to those who have already seen the Graphical Meshing interface. With the exception of the menu and tool buttons loaded, mesh refinement and mesh seeding actually uses a variant of the “post3” interface. Major points of interest are indicated. Remember that tool button functions can be indicated in the status bar at the bottom of the window by pressing and holding the button for which information is desired. Merely move the cursor off of the button while it is still depressed to release without selecting. As with the Modeler (Draw), the Material Manager, and Boundary manager, the keyboard CTRL-drag, SHIFT-drag, and CTRL-SHIFT-drag shortcuts for rotate, pan, and zoom (respectively) all function here as well, making view manipulation a snap. * Plotting the mesh doesn’t provide any direct data about the solution itself, but it does allow you to see where the mesh concentration was increased by the adaptive process (and/or by your own seeding and refinement steps) to help you determine if the code ‘saw’ the behavior you were trying to model. In some cases, it can also show you locations where your input data was faulty. For example, if the model geometry was input from a .dxf file, two vertices which were extremely close together could result in a non-uniform mesh density in a location where you would not expect it to be necessary from a field standpoint. Seeing the mesh might therefore help you determine whether or not you wish to accept the data already existent, or perhaps go back and modify the model to remove the offending vertices and obtain a higher quality mesh. Different mesh display rendering is available. Note that certain mesh display rendering is