ISO230-2-2006数控机床常见检测标准（一）.pdfVIP

INTERNATIONAL ISO STANDARD 230-2 Third edition 2006-03-15 Test code for machine tools — Part 2: Determination of accuracy and repeatability of positioning numerically controlled axes Code dessai des machines-outils — Partie 2: Détermination de lexactitude et de la répétabilité de positionnement des axes en commande numérique Reference number ISO 230-2:2006(E) © ISO 2006 ISO 230-2:2006(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. © ISO 2006 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or me