CGMP文件-实验室废弃物管理程序SOP.docVIP

文件编码Doc. No.: Page No.: PAGE 4 of 4 标题：实验室废弃物管理程序 TITLE: PROCEDURE FOR LABORATORY WASTE HANDLING 制定人 Prepared by 审核人 Reviewed by 批准人 Approved by 签名/日期 Sign / Date 名字 Name 职务 Designation 标准操作程序 Standard Operating Procedure 文件编码Doc. No.: 颁发日期： Issue Date: 生效日期： Effective Date: 替代： Supersedes: 复审日期： Review Date: 页码：第1页共4页Page No.: 1 of 4 标题：实验室废弃物管理程序 TITLE: PROCEDURE FOR LABORATORY WASTE HANDLING 制定人 Prepared by 审核人 Reviewed by 批准人 Approved by 签名/日期 Sign / Date 名字 Name 职务 Designation 1.0　目的　Purpose : 规定实验室废弃物的收集、处理程序。确保废弃物的排放能符合国家有关环境排放标准。 Define the procedure for collecting and handling the laboratory waste, thus ensure that the waste discharge meets the related national environmental requirements. 2.0　范围　Scope : 该规程适用于实验室废弃物。 This procedure applies to the laboratory wastes. 3.0　定义　Definitions : 废弃物：指检验用剩余试药、试液、检验后的反应液等。 Waste: refers to the remained reagents, solutions and the reaction solutions after testing. 4.0　责任　Responsibility: QC 检验员/组长/经理助理/经理 QC analysts/Group Leader/Manager Assistant/QC Manager 5.0　程序　Procedure : 5.1 无毒无害的废弃物倒入废液桶后，在检验完毕后由化验员直接倒入下水道中。 Un-toxic and un-hazardous waste could be poured into the waste bucket, and directly poured into sewer after finishing the test. 5.2 实验室的少量废气一般可通过通风橱或通风管道，经空气稀释排出。 Small amount of waste gas could be diluted by air, and then discharged from fumehood or air-duct. 5.3 大量的有毒气体必须通过与氧充分燃烧或吸收处理后才能排放。 Large amount of hazardous gas should be first thoroughly burned with oxygen, or treated by absorption before discharge. 5.4 有毒有害的废弃物倒入专门废液桶，由专人按下列规定立即处理。 Hazardous and toxic waste should be collected in designated bucket, and then treated by designated people, following the rules below: 5.4.1 无机酸类：用1%碳酸钠或1%氢氧化钙溶液中和，中和后用大量水冲洗。 Inorganic acid: neutralized with 1% sodium carbonate or 1% calcium hydroxide, and then washed with large amount of water. 5.4.2 氢氧化钠、氨水等无机碱类：用6mol/L盐酸溶液中和，用大量水冲洗。 Inorgani