JuniperJunosSRX系列ClusterHA配置汇总.docVIP

. . 1.插线 指定主备 On device A: set chassis cluster cluster-id 1 node 0 reboot On device B: set chassis cluster cluster-id 1 node 1 reboot 定义控制层端口 （可配置网管口） On device A: {primary:node0} set groups node0 system host-name HQ-CS-FW-SRX550-1 set groups node1 system host-name HQ-CS-FW-SRX550-2 set apply-groups ${node} //必配 ----------------- ?set groups node0 interfaces fxp0 unit 0 family inet address ip address/mask ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ?——Device As management IP address on fxp0 interface ?set groups node1 interfaces fxp0 unit 0 family inet address ip address/mask ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ?——Device Bs management IP address on fxp0 interface ----------------配置网管地址 各设备型号控制线端口 ? SRX Series Chassis Cluster Slot Numbering, and Physical Port and Logical Interface Naming 4.定义数据层端口 On device A: {primary:node0} -fab0 is node0 (Device A) interface for the data link # set interfaces fab0 fabric-options member-interfaces ge-0/0/2 -fab1 is node1 (Device B) interface for the data link # set interfaces fab1 fabric-options member-interfaces ge-9/0/2 5.配置 redundancy-group {primary:node0} set chassis cluster redundancy-group 0 node 0 priority 100 set chassis cluster redundancy-group 0 node 1 priority 50 set chassis cluster redundancy-group 1 node 0 priority 100 set chassis cluster redundancy-group 1 node 1 priority 50 注： Redundancy Group 0 for the Routing Engine failover properties 必配 ? ? ?Redundancy Group 1 to define the failover properties for the Reth interfaces ? ? ? (all the interfaces will be in one Redundancy Group in this example) 建议所有端口放一个Group 6. 配置 端口监控 On device A: {primary:node0} set chassis cluster redundancy-group 1 interface-monitor ge-0/0/3 weight 255 set chassis cluster redundancy-group 1 interface-monitor ge-0/0/4 weight 255 set chassis cluster redundancy-group 1 interface-monitor ge-9/0/3 weight 255 set chassis cluster redundancy-group 1 interface-monitor ge-9/0/4 weight 255 注：监控所有端口 ? ? Interface monitoring is not recommended for redundancy-group