vav空调的最佳控制20111120.pptVIP

* 要么，安装在任一风道上OK, let’s mount the sensor on either duct. [CLICK] 可是如果没有客户呢But if there is no tenant in this side, [CLICK] 我们必须保持这里的压力But we need to assure this pressure Pointing out the mark [CLICK] 如果两个风道都安装呢，在控制中还是只能使用一点OK, let’s mount on both ducts. But usually, the controller can display only one point at point schedule. [CLICK] 因为追加了1个传感器，随来为增加的传感器买单呢Since one more sensor is added, who burden the extra cost? 设备损坏的风险也增加了Also, the risk of equip. failure is increased. 很难找到合适的位置，增加风险和成本，还不节能Difficult to find the appropriate location, Increased Risks and costs, No energy savings… 常规的有那么多的麻烦 There are so many difficulties exist on the conventional way [CLICK TO NEXT] * 当使用AZBIL的VAV控制的时候，VAV控制器和AHU控制器互相通讯While azbil VAV Control, VAV controllers and AHU controllers communicate each other. [CLICK] 每个VAV控制器传递需求，AHU控制器计算VSD的速度。Each VAV controller transmits its demand and AHU controller calculate the VSD speed. [CLICK] 所以，压差传感器不需要So, no differential pressure sensor is required, [CLICK] AHU只提供VAV的需求风量AHU only supplies the air flow as all VAVs demand. * 与有没有客户没有关系No matter there is a tenant or not, [CLICK] 至少最小的风量会送给所有的区域，浪费很多能量，我们需要能够根据客户时间表进行控制的Minimum air always supplied to all zones. That is so much energy wastes… We need VAV control flexibly by the tenant schedule. [CLICK TO NEXT] * Azbil VAV 能够根据客户时间表进行控制can control VAV as tenant schedule. [CLICK] 当客户没有使用时，关闭VAV，使用时马上打开When this tenant is not used, turn off VAV, and turn on VAV when that tenant start using. Pointing out the rooms 只根据客户区域时间表送风，他带来很大的节能效果 Only supply air needed by matching each zone schedule. That leads to great energy saving effects! [CLICK TO NEXT] * [CLICK] 即使客户楼层改变了Even when floor layout is changed, [CLICK TO NEXT] * 灵活的区域控制还是可以调节Flexible Zone control is available. [CLICK TO NEXT] * Azbil VAV有灵活的区域控制，避免了能量浪费 has flexible zone controls. And that eliminates energy wasting. [CLICK TO NEXT] * When AHU fan stopped, stop all VAV at maximum openings. [CLICK] When AHU start again, All VAVs opened at maxi