LTE系统信令流程三.pptVIP

LTE系统信令流程(三) * Spec 23.401 5.3.4.1 UE triggered “Service Request” Procedure UE发起的”service request”流程 Spec 23.401 5.3.4.3 Network triggered “Service Request” Procedure The purpose of the service request procedure is to transfer the EMM mode from EMM-IDLE to EMM-CONNECTED mode and establish the radio and S1 bearers when uplink user data or signalling is to be sent. Another purpose of this procedure is to invoke MO/MT CS fallback or 1xCS fallback procedures. This procedure is used when: 1 the network has downlink signalling pending; 2 the UE has uplink signalling pending; 3 the UE or the network has user data pending and the UE is in EMM-IDLE mode; 4 the UE in EMM-IDLE or EMM-CONNECTED mode has requested to perform mobile originating/terminating CS fallback or 1xCS fallback; 5 the network has downlink cdma2000? signalling pending; or 6 the UE has uplink cdma2000? signalling pending. The service request procedure is initiated by the UE, however, for the downlink transfer of signalling, cdma2000? signalling or user data in EMM-IDLE mode, the trigger is given by the network by means of the paging procedure. The UE shall invoke the service request procedure when: a) the UE in EMM-IDLE mode receives a paging request with CN domain indicator set to PS from the network; b) the UE, in EMM-IDLE mode, has pending user data to be sent; c) the UE, in EMM-IDLE mode, has uplink signalling pending; the UE in EMM-IDLE or EMM-CONNECTED mode is configured to use CS fallback and has a mobile originating CS fallback request from the upper layer; the UE in EMM-IDLE mode is configured to use CS fallback and receives a paging request with CN domain indicator set to CS, or the UE in EMM-CONNECTED mode is configured to use CS fallback and receives a CS SERVICE NOTIFICATION message; the UE in EMM-IDLE or EMM-CONNECTED mode is configured