昆腾系列PLC硬件特性.pptVIP

Module 02 Page * REFERENCE HARDWARE MANUAL - APPENDIX C Quantum backplanes are available in 2, 3, 4, 6, 10, and 16 module slot versions. Backplane selection consists of merely choosing the model with enough available slots to hold the required modules and future expansion. The above section in the manual lists all the mounting dimensions and directions that you’ll ever need. 19” NEMA cabinet mounting bracket types and dimensions are also specified. Module 02 Page * Modules are very easy to install / remove. Terminal strips are removable and are indeed a separate orderable item. This allows for pre-wiring modules or easy replacement of defective module without affecting the wiring. To maintain a 4 inch module depth, the module wiring is brought in from the bottom behind the removable door. The door cover comes with everything you need to label the module. Pay particular attention to the Grounding location. Ensure that you provide a ground to the backplane as indicated. Module 02 Page * Insert a module at an angle on to the two hooks located on the top of the backplane. Swing the module down to make an electrical connection with the backplane I/O bus connector. Tighten the screw at the bottom of the module to fasten it to the backplane. The maximum tightening torque for these screws is 2-4 in-lbs. Module 02 Page * The idea of “Hot Swapping” modules has been a concept discussed by a number of PLC manufacturers for years. With the introduction of the Quantum Automation Series, “Hot Swapping” is truly a reality. All modules in Quantum can be Hot Swapped. I/O Modules, CPU Modules, and Power Supplies. Caution: An I/O module can only be hot swapped with the field side terminal strip removed. All modules have a built-in electronic module ID which identifies what type of module is installed in a given backplane slot. Any module can go in any slot. If the installed modules don’t match the software configuration, however, the modules that are installed in the incorrec