co2系统试验程序.docVIP

CO2 SYSTEM TEST PROCEDURE PAGE 6 / 4/ 5PAGEAREA : 0.0625 m2 CO2 SYSTEM TEST PROCEDURE PAGE 6 / 4 / 5 PAGE AREA : 0.0625 m SCOPE 适用范围 This test procedure shall be applied to the operation function test of CO2 Fire Extinguishing System for 30000LBC Bulk Carrier. 本程序适用于30000吨散货CO2系统的操作及性能测试. TEST CONDITION 试验条件 2.1 Piping system installation completed. 系统安装的完整性和正确性检查结束。 2.2 Piping tightness test have delivery to owner. 系统（包括施放管路和控制管路）密性交验结束。 2.3 Disconnect the flexible hose from the outlet of the cylinder top valves, and fix the closing nut to the outlet of the valve. 断开所有瓶头阀软管，在阀出口安装上锁紧装置。 3 TEST PROCEDURE 试验程序 3.1 Cover the co2 nozzles with paper and open the master valve use compress air to check the air distribution and the nozzle spray condition. 将CO2喷头用纸封住，连接空气/通岸接头并送气（压缩空气）至总管，打开主阀，检查分配管路和喷嘴的畅通性. 3.2 Alarm function test 报警功能试验 3.2.1 Alarm for power source failu 系统电源故障报警试验（延伸到集控室）。 3.2.2 Alarm for Co2 leakage (with extension to ECR CO2泄漏报警试验（延伸到集控室）。 3.2.3 E/R，INCIN.ROOM Alarm for Co2 release(with extension to ECR) 机舱，焚烧炉CO2释放报警试验（延伸到集控室） The alarm sirens/flash lights will be activated by either of the below mentioned systems. 在以下提及的系统中必须启动闪光及信号报警器： Open the release cabinet door for engine room, check the alarm sirens/flash lights in engine room. 打开机舱CO2释放控制箱, 检查机舱信号报警器发声，报警灯闪光. Open the CO2-master valve for engine room manually. 手动打开机舱CO2释放主阀, 检查机舱信号报警器发声，报警灯闪光. Open the release cabinet door for incinerator room, check the alarm sirens/flash lights in incinerator room. 打开焚烧炉间CO2释放控制箱, 检查焚烧炉间信号报警器发声，报警灯闪光 Open the CO2-master valve for incinerator room manually. 手动打开焚烧炉间CO2释放主阀, 检查焚烧炉间信号报警器发声，报警灯闪光. 3.3. Cut off of Fans 3.3 风机切断试验 The ventilation and shut down will be activated by either of the below mentioned systems. 下列操作时，风机应改停止。 Activated by the CO2-release cabinet. CO2施放箱操作。 3.3.1 open engine room CO2 release cabinet door 打开机舱CO2施放箱门 check that the ventilation fans in protected areas have stopped. 检查机舱风扇已经停止 No.1 E/R VENTILAT