超细高长径比硅灰石制备技术研究_刘新海.pdfVIP

2 8 2 非金属矿 V ol.28 No.2 2005 3 　　　　　　　　　　　　　　　　Non-M etallic M ines 　　　　　　　　 　　　　　　　　　 M ar., 2005 ＊ 1 1 2 1 1 刘新海 　杨友生 　沈上越 　杨康平 　李一波 (1　, 　450006;2　(), 　430074) 　　对制备超细高长径比硅灰石的研究从破 阶段开始就注重对其针状晶体的保护, 采用长腔颚式破 , 使破 作用于硅灰石矿 物上的力分别以挤压力和摩擦力为主, 避免过粉 , 可有效地保护粗颗粒硅灰石的针状晶体结构。 采用多种超细粉 设备对硅灰石进行超细 粉 , 结果表明, Q L M-Ⅳ型流化床式气流粉 系统在磨腔工质压力为0.7 ～ 0.8M Pa, 轴承防护气体压力为0.20M P a、清洗气体工作压力为 0.15M P a、分级轮转速2000r/min 的工艺条件下, 粉 产品平均粒度为5.60μm, 长径/短径高达 16.17。 　硅灰石　高长径比　粉 方法　流化床式气流粉 Study on The Preparation T echniques o Ultra ine High Aspect Ratio W ollastonite 1 1 2 1 1 Liu Xinhai 　Yang Yousheng 　Shen Shang yue 　Yang K ang ping 　Li Yibo (1　Z henzhou Inst itu te o M ultipurpose Ut ilization o M ineral Resources, CAG S, Zhenzhou 　450006;2 　College o M aterial Science and C hemical Engineering, China U niversity o G eosciences, Wuhan 　430074) Abstract　T he prot ect ion o wollast onit e needle cry stal st ructure w ere rom crush stage by use t he long jaw type crusher.T he orces dinted on the mineral are mainly squeeze and riction, avoided smashing, so the needle cry stal struct ure o minerals can protect avai lably .T he variety o the su- per ine grinding equipments are used t o crush w ollastonite, and the result s indicat ed that, t he grinding room air pressure is cont rolled bet w een 0.7 ～ 0. 8 M P a o the type o Q LM -Ⅳ luidized bed opposed jet mill, the beari ng prot ect ion air pressure is 0.20 M Pa, t he w ash air pressure i s 0.15 M P a, and the velocity o classi ication w heel is 2000r/min.A t t hese conditions t he product average si ze is 5.60μm, it s average lengt h/diameter is up to 16.17. Key words　w ollast oni te　high aspect ratio 　crush met hods　 luidized bed op