方钢管高强混凝土短柱有限元分析.pdfVIP

学兔兔 36 江苏建筑 2011年第6期(总第 145期) 方钢管高强混凝土短柱有限元分析 郎美 ．杨志坚 ( 宿迁学院建筑工程系。江苏宿迁 223800； 天津大学建筑工程学院，天津 300072) [摘 要】 文章基于冷弯型方钢管高强混凝土短柱试件的轴心受压试验，采用ABAQUS通用有限元分析软件对试件的轴 压工况进行数值计算。采用舍理的材料本构方程、建模与网格划分方法，使有限元计算结果与试验结果吻合较好 O分析了在 荷载一应变典型曲线特征点时轴压短柱试件的核心混凝土横截面轴向应力分布和试件在各阶段的受力性能。得到如下结论： 钢管的冷弯区域决定了核心混凝土横截面轴向应变的分布；轴压短柱达到极限承栽力时，核心混凝土由于方钢管的约束作 用，其抗压强度得到明显提高：文章采用的有限元模型在分析冷弯型方钢管高强混凝土轴压短柱时是可行的。 f关键词1 冷弯方钢管；核心混凝土；高强；有限元 【中图分类号]TU392．1 『文献标识码1A 『文章编号]1005—6270(2011)06—0036一o3 Finite Element Analysis of High Strength CFSST Stub Columns LANG Yah YANG Zhi-jian (1．Department of Building Engineering，Suqian College，Suqian Jiangsu 223800 China； 2．School of Civil Engineering，Tianjin University，Tianjin 300072 China) Abstract： Based on previous research on the experimental study of high strength concrete-filled square cold- formed steel tubular(CFSST)stub columns，a finite element software ABAQUS was employed to analyze the mechanical behaviors of the stub column under axial compressive load．The results obtained from the finite el— ement analysis were verified against experimental results with reasonable constitutive equations，finite element modeling and meshing． This paper discussed mechanical characteristics during the test with finite element method results．Some conclusions were drawn as follows：The area of cold-formed square tube determined the distribution of axial strain on the middle crOSS—section of core concrete． Because of confinement effect of square tube， compressive strength of core concrete was．enhanced．The element analysis modeling used in the paper was practicable in simulating high strength con