模具设计DFM模板.知识讲稿.pptVIP

擦穿位置分析 Shut off position Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG 此面插穿角不够，需修到3度 产品出模分析 Product Draft analysis Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG Draft analysis Draft OK * * * * * * * * * * * * * FS0000F DFM Report DFM Engineer：LIMIN Approved: Date：2014/02/26 DFM – Design For Manufacture Five-Star Tooling Limited Project name: Mould No. FS0000E Customer Name UKAG Customer mould No. 请客人提供 Part No. Screen Side Frame Cavities 1+1 Material PC/ABS BAYER T65XF Size for 1 part 182.7X126.9X35 Inch/mm mm 产品信息 Product Information 上下模分析 CAV/COR Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG cavity side core side 进浇口建议 Gate Advice（方案一） 冷流道，两点潜水入胶 170mm 冷流道，潜水入胶。优点：不需热流道板。缺点：流道长，注塑压力大。 模具排位，模胚尺寸为5565 进浇口建议 Gate Advice（方案二）（推荐） Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG Moldmaster 1 open nozzle HRM / Sub Gate Hot Sprue Sub Gate 由于产品较大，同时根据排位需要，我们建议客人每个产品用一个热转冷流道，两点潜水。（请客人确认热嘴的型号并确认是否需要订购接线盒，并提供具体品牌及型号，接线方式。）同时，请客人确认另一个产品是否为完全镜像关系。请市场考虑增加热嘴报价。 热嘴转冷流道潜水入胶。优点：流道短，注塑压力小，产品填充好。缺点：需要热流道板，模具成本相应增加。 模具排位，模胚尺寸为5565 Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG 结构分析 Structure analysis Structure Quantity Slide 1 Lifter 0 Collapasible core / Core slider 01 C C C-C见下页 Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG 结构分析 Structure analysis Core side ST1=8 ST2=20 8 SECTION C-C 自制定位零件，底部加弹弓 Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG 镶件分析 Insert analysis Cavity Insert 做浮动镶件，避免产品粘前模 10 Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG 镶件分析 Insert analysis Core Insert 下模三个镶件，每个镶件上下两支扁顶针 Customer comment. (please give your approval and c