配置HRB600级高强钢筋无黏结部分预应力混凝土梁变形性能试验研究.pdfVIP

2016年第2期 混凝土 与水泥制 品 2016 No．2 2月 CHINA C0NCRETE AND CEMENT PRODUCTS February 配置HRB600级高强钢筋无黏结部分预应力 混凝土梁变形性能试验研究 赵少伟，宋 昌，师长磊 (河北工业大学土木工程学院，天津300401) 摘 要：对5根无黏结部分预应力混凝土梁进行了抗弯试验，分析了预应力度和非预应力筋强度等级对构件变形 性能的影响。结果表明：配置HKB600部分预应力的混凝土桥梁构件开裂前刚度按照JTGD62--2004((路钢筋混凝 土及预应力混凝土桥涵设计规范》相关公式计算是合理的；预应力度的提高可以延缓试验梁开裂后挠度的发展，但对 极限破坏时的挠度变化影响不大：提高钢筋等级可延缓构件开裂后刚度下降速率；提高预应力度和增加钢筋等级都 会提高梁体的延性，增加其恢复变形能力。 关键词：HR．B600级钢筋；无黏结部分预应力；混凝土梁；受弯性能试验；变形性能；刚度 Abstraet：Based on flexural behavior experiment of five un—bonded partially pre-stressed concrete beams．the flexural load-carrying capacity was studied，the effect of prestress degree and strength of non—prestressed bars on the deformation performance was analyzed．The experimental resuhs indicate that．it is reasonable山at the correlation formula of JTG D62— 2004 Co for如st of high way reinforced concrete and prestressed on concrete bridges and culverts is used to the stiffness calculation of unbonded partially prestressed concrete beams tll HRB600 nonprestressed tendons． nle developing rate of the test beams deflection after cracking is delayed with the prestress degree decreases，while the deflection little changes with their failure．The application of high-strength steel can delay the decrease rate of member stiffness after cracking．And degree of prestress and the strength of non—prestressed bars can both reduce the ductility of girder body and increase its restoration of capacity to deformation． Key words：HRB600 steel bar；Un-bonded partially prestress；Concete beam；Flexural behavior experiment； Deformation performance；Stiffness 中图分类号：TU528．79 文献标识码_^ 文章编号：1000—4637(2016)O2—46—05 0 前言 应力筋的预应力混凝土梁的受弯性能与一般预应 HRB600级钢筋是一种强度高、性