Q_TL1010-2008内饰材料阻燃特性要求企业标准.pdf

TL 1010 Group Standard Issue 2008-01 Class. No.: 55000 Descriptors: flammability, combustibility, burning behavior, flame retardance, interior trim D Materials for Vehicle Interiors Burning Behavior, Material Requirements Previous issues TL 1010: 1971-10, 1972-04, 1972-09, 1974-08, 1975-09, 1985-02, 1993-01 Changes The following changes have been made as compared to Technical Supply Specification TL 1010: 1997-05: ─ Section 3.1 expanded 1 Scope This Technical Supply Specification defines requirements for the burning behavior of materials/ components in the passenger compartment. It pertains to every part of a single or composite material whose surface contacts the air space of the passenger compartment and that is located within a maximum depth of 13 mm (1/2 inch) from the passenger compartment surface. For parts that are joined over less than the full surface area and that succeed each other during assembly, the depth of 13 mm shall be taken into consideration again after removal of the part closest to the passenger compartment (see Figure 1), until a layer exists that is thicker than 13 mm or an overall depth of 26 mm (1 inch) has been reached. 2 Definitions M a t e r i a l s / c o m p o n e n t s o f t h e p a s s e n g e r c o m p a r t m e n t : seat cushions, back- rests, seat belts, roof liners, folding tops of convertibles, arm rests, all trims, shelves, headrests, floor coverings, sun visors, curtains, blinds, seat coverings and all other materials used in the pas- senger compartment, including padding and elements that deploy in the event of a crash whose intended purpose is to absorb energy during a crash. Check standard fo