美国材料协会标准 A128 - A 128M - 19.pdf

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. Designation: A128/A128M − 19 Standard Specification for Steel Castings, Austenitic Manganese1 This standard is issued under the fixed designation A128/A128M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (´) indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the U.S. Department of Defense. 1. Scope* of this specification and Specification A781/A781M, this 1.1 This specification covers Hadfield austenitic manganese specification shall prevail. steel castings and alloy modifications. 4. Ordering Information 1.2 The values stated in either inch-pound units or SI units 4.1 Orders for material under this specification should are to be regarded separately as standard. Within the text, the include the following information in proper sequence: SI units are shown in brackets. The values stated in each 4.1.1 Quantity, system are not exact equivalents; therefore, each system must 4.1.2 Specification, grade, be used independently of the other. Combining values from the