f7 连线指南新—中英繁.docVIP

F7 Quick Connection Guide F7 Quick Connection Guide PAGE 2 Due to continuous product updates, we dont promise the actual product is the same as the document。 PAGE 1 Due to continuous product updates, we dont promise the actual product is the same as the document。 F7 Quick Connection Guide Connection between F7 terminal and power supply F7 terminal is shown in above figure. It supports DC power supply of 9-15V as input, and can work immediately through the direct connection between GND and ＋12V . If lock-control uses the individual power supply, the current of F7’s power supply adapter applies matching current of 500mA or over; if lock-control uses the same power supply with F7, the nominal output current of the power adapter will exceed the working current by over 1000mA. GND GND +12V Power RS232 RXD Lock COM RS232 TXD Lock NO GND Lock NC RS485 A GND RS485 B Alarm＋ GND Alarm— DATA0 Button DATA1 GND +5V Output Bell＋ Door Sensor Bell— GND 9—15VPower supply adapter + 9—15V Power supply adapter + Connection with door lock F7 can support normal-open and normal-closed door lock simultaneously, so long as it is connected with the different terminals respectively. Usually, lock No terminal disconnects with COM terminal, and they connect when F7 outputs the unlocking signal and recover to disconnection when the signal ends. The connection and disconnection between Lock NC terminal and COM terminal is opposite to above situation, they connect usually and disconnect when the unlocking signal is output. Due to the existence of varied electric-control door locks, the correct connection method must be confirmed in accordance with the door lock specification: Lock NO terminal should be used for the locks, which unlock when the power is on and lock when power is off; otherwise, the Lock NC terminal should be used. Take the electric-control lock, which locks usually when power is off, for example herein, to show the connectio