PowerFlex700变频器调试与故障排除培训资料.ppt

The LCD HIM Fault Queue F At Speed Auto 26.01 Hz 1 Flt Q# : F# 85 Port 5 DPI Loss Fault’s Number in the Queue Fault Code Fault Title Accum: 131:55:51.240 Time Stamp The DriveExplorer Software Fault Queue Drive Status Fault’s Number in the Queue Fault Code Fault Title Time Stamp The DriveExecutive Software Fault Queue Drive Status Fault Code Fault Title Clearing a Fault 引起故障的原因必须查明并解除后，故障才可以清除。 要清除故障可以: 按HIM 上的停止按钮。 或 Click “Clear Fault” in Faults tab in DriveExplorer software 或 Click “Clear Faults . . .” in Faults tab in DriveExecutive software PowerFlex 700? 变频器 负载和环境因素的故障排除 Load smaller than motor’s maximum rating: Load Faults Load at motor’s maximum rating: Load Faults Motor Overload Load larger than motor’s maximum rating: Load Faults Load Faults 负载故障类型: 马达过载 Motor OverLoad 硬件过电流　HW OverCurrent 软件过电流　SW OverCurrent 超速过限　　OverSpeed Limit 安全销故障　Shear Pin 变频器过载　Drive OverLoad An incorrectly applied drive can result in component damage or a reduction in product life. Application errors such as undersizing the motor may result in malfunction of the system. Environmental Faults 在如下情形下发生环境故障: 变频器接受到太少的功率 变频器接受到太多的功率 变频器周围有过多的热量 变频器内部有过多的热量 Excessive Heat Excessive Heat Excessive Heat Excessive Heat Environmental Faults Environmental Faults Types of environmental faults: 动力缺失　　Power Loss 母线低电压　UnderVoltage 母线过电压　OverVoltage 散热片过温　Heatsink OvrTemp 晶体管过温　Trnsistr OvrTemp 控制板过温　Cntl Bd OvrTemp Ambient Operating Temperatures 0° to 40° C 　周围温度 操作在 41° and 50° C 之间的周围温度: 除20BC072以外所有变频器把顶部标签撤掉，可工作在50° C 20BC072: 顶部标签撤掉，可工作在 45° C 顶部标签和通风板撤掉，可工作在50° C Removing the adhesive label from the drive changes the NEMA enclosure rating from Type 1 to Type Open. The vent plate can be removed by lifting the top edge of the vent plate from the chassis and rotating the vent plate out from the back plate. Minimum Mounting Clearances 避免增加过多的热量: No Adhesive Label Adhesive Label PowerFlex 700? 变频器 设备故障排除 Fault Code Equipment Problems 设备故障类型: 通讯口故障 软件故障 编码器故障 I/O故障 主控制板故障 存储器故障 其它硬件故障