塑料模专业英语——其实世界上最美的景色就是落日与朝阳偶的小小.pdfVIP

1ejector unit ejector pin, ejector plate,ejector sleeve,ejector rod, ejector leader busher ejector guide bush ejector stopper, ejector pin retaining plate: ejector guide pin: 2dual color injection machine for Plate sheet-Shaped 3weldline 4electrode : 5gas mark 6Unless you are Amish, you probably come into direct contact with injection molded products constantly. Even if you are Amish, you could very well come in contact with an injection molded product, such as an armrest on a bus or train. Amish Amish Amish , 7texturing 8ejector marks 9flash burr “” :ejector mechanism 10fitter: die makeermold makertooling maker 11Some Typical Complications Burned or Scorched Parts: Melt temperature may be too high. Polymer may be becoming trapped and degrading in the injection nozzle. Cycle time may be too long allowing the resin to overheat. Warpage of Parts: Uneven surface temperature of the molds. Non-uniform wall thickness of mold design. Surface Imperfections: Melt temperature may be too high causing resin decomposition and gas evolution (bubbles). Excessive moisture in the resin. Low pressure causing incomplete filling of mold. Incomplete Cavity Filling: Injection stroke may be too small for mold (ie. not enough resin is being injected). Injection speed may be too slow causing freezing before mold is filled. 12cold/cold-pressed/cold-coining/cold-compacting 13 triming line 14It was probably because the functional relationship between the punch load and the die profile, though admissible, was not formulated with due emphasis on the smooth flow along the toroidal profile of the die. “ It was because that + The relationship was not fomulated with “ ”( ) “” 15: Anglar pin or Lifter sprue bushing :angle guide pin : trail shot sample :trail shot production 16Inserted Areas / Interchanges A - Side: B - Side: Cams: Panel Lamp Lense