第六部分 505服务模式.pptVIP

Service 模式 505 / 505E Speed Control 转速控制 Speed Setpoint rates 转速设定值的速率 Rate to minimum governing speed(pgm) 到最小调速器转速的速率 Slow rate(pgm) 慢速率 Fast rate delay 快速率延时 Fast rate(3xslow rate) 快速率 Entered rate(Slow rate) 键盘直接键入设定值时的速率 Underspeed Setting 欠转速设定 Only used if an underspeed relay is programmed. 仅当组态了欠转速继电器时才可用 Defaulted to 100 RPM below the minimum governing speed. 默认值为最小调速器转速-100 RPM Derivative Ratios 微分系数 Hold Changes? 保持改变？ The “Hold xxxx Changes?” must be set to yes to keep the Service Mode changes active. Otherwise the 505 will default to the Configure Mode defaults the next time the