HFSS仿真角锥天线.pptVIP

建模尺寸 一、创建工程 一、创建工程 一、创建工程 一、创建工程 二、创建模型 二、创建模型 二、创建模型 二、创建模型 二、创建模型 二、创建模型 二、创建模型 三、设置边界条件和激励源 三、设置边界条件和激励源 三、设置边界条件和激励源 四、设置求解项并分析 四、设置求解项并分析 四、设置求解项并分析 五、察看结果图 五、察看结果图 五、察看结果图 五、察看结果图 * 例题：角锥喇叭 6in 4in 3in 5.16in 1.944 2.65 0.4in 0.9in 0.315in Air box Horn Antenna The base of the Horn 第一步：打开HFSS并保存新工程 打开 HFSS 软件后，自动创建一个新工程： Project1。 由主菜单选 File\Save as ，保存在指定的文件夹内，命名为horn。 第二步：插入HFSS设计 由主菜单选 Project\ Insert HFSS Design，则一个新项目自动加入到工程树中，默认名 HFSSModel1。同时，在工程树的右侧出现绘图窗口。 在工程树中选择 HFSSModel1，点右键，选择 Rename项，将设计命名为 HornModel。 第三步：选择求解类型 由主菜单选 HFSS\Solution Type ，在弹出对话窗选择Driven Model 项。 第四步：设置单位： 由主菜单选 3D Modeler\Units ，在 Set Model Units 对话框中选中 in 项。 Drawing the base of the Horn Click the Box icon or go to DrawBox. Enter the following values -0.2, -0.45, and 0 for x, y and z, respectively and 0.4, 0.9, 0.315 for dx, dy, and dz, respectively The drawing is with respect to the origin (0, 0, 0). In other words, the base of the horn is drawn with the (0, 0) as its center. Drawing the base of the Horn Type Base in the name field. Material assigned is vacuum and choose Color and Transparent at your preference. Click Ok. Drawing the base 2D Rectangle To create the “funnel” or tapering of the horn antenna, draw and connect Two rectangles, and then connect them to create the 3D funnel. Place the first rectangle on top of the 3D antenna base. DrawRectangle. Now move the cursor to one corner of the top of the antenna base, and click on it, then move the cursor to the opposite corner of the top of the antenna base and click again. The rectangle window is open. Type funnel_base. Assignmaterial to be vacuum. Choose Color and Transparency of your preference. Click Ok. Note that the dimensions of the rectangle should match those of the top of theantenna base. Drawing the Horn Aperture Next, draw the 2D rectangle that represents the top of the funnel, or the aperture of the horn. Click Rectangle icon or DrawRect