Quality-Control-Plan(中英文对照)教学案例.docxVIP

1 质量保证计划 Quality Control Plan （项目编号：TRSC/1701152） Project No:TRSC/1701152 2017年7月17日 07-17-2017  质量保证计划 Quality Control Plan 概述 General Description 1.1 目的 Purpose 为满足张家港特锐机械制造有限公司采购项目，项目编号：TRSC/1701152的要求，制定如下专项质量保证计划。 To meet the requirement of Tedrail (Project No.: TRSC/1701152), make the following quality control plan: 2. 质量目标 Quality Objectives 根据该项目合同及附件中有关技术要求，满足下述质量目标： 满足首检确认后双方达成一致的《产品技术规范》及《产品部件尺寸验收质量表单》等质量要求 According to the relevant technical requirements of the project contract, meet the following quality objectives: Meet the FAI confirmed that the two sides agreed to reach a consensus on the product delivery and acceptance specification and product parts size and acceptance quality form and other quality requirements 3. 技术准备Technical Preparation 为保证满足本项目零件的制造、检查和验收的技术要求，供应商应建立和贯彻有效的质量控制程序，用以保证产品的设计质量。 To meet the requirements of the project of parts manufacturing, inspection and acceptance of the technology, supplier should establish and implement an effective quality control procedures, to ensure the quality of product design. 3.1 技术输入 Technical input 将技术协议书和其它必要的文件将作为编制技术文件的依据。 The technical agreement and other necessary documents will be used as the basis for the preparation of technical documents. 3.2 技术输出 Technical output 3.2.1 工艺人员编制工艺文件、检查卡片等技术文件输出： Process documentation, inspection cards and other technical documents output: 3.2.2 输出文件要符合有关标准、规范且正确、完整，经项目设计负责人批准后才能发放。 The output file should be in accordance with the relevant standards, norms and correct, complete, approved by the person in charge of the project design to be issued. 3.3 技术验证Technology verification 在项目技术经理主持下，由车间组织技术人员和有关部门专业人员对产品设计和工艺进行确认。 Under the auspices of the project technical manager, the technical staff and the relevant departments of the workshop to confirm the product design and process. 4 生产过程控制Production Process Control 4.1 工作内容Job Content 为使该项目产品生产过程具有实现产品设计要求的能力，用较先进的工艺技术，以及合理的制造成本，确保制造的产品能够完全达到设计要求和相关标准要求。 In or