岩芯回弹测试方法-中国测试杂志社.pdf

第43卷第9期 中国测试 Vol.43 No.9 2017年9月 CHINA MEASUREMENT TEST September，2017 doi院10.11857/j.issn.1674-5124.2017.09.007 岩芯回弹测试方法 袁广祥袁 王朋姣袁 李建勇袁 黄志全袁 赵 菲 渊华北水利水电大学资源与环境学院袁河南 郑州 450045冤 摘 要院为利用回弹仪快速确定岩芯强度袁根据回弹仪的原理和岩芯的特征袁对岩芯回弹测试方法进行研究遥 在选择 回弹仪型号时袁轻型为宜袁0.735J 的最佳曰为保证回弹仪垂直冲击岩芯表面袁且在冲击过程中岩芯不发生回弹袁应使 用辅助装置袁包括钢基座和导向管曰测点均匀布置在某一横断面的圆周上袁间隔90毅袁每个测点锤击 1次袁记录回弹 值遥由于岩芯回弹测试垂直向下锤击袁应对回弹值进行修正袁然后再取4个测点回弹修正值的平均值作为岩芯在这一 断面处的回弹值遥 通过回弹试验发现袁利用这种方法获取岩芯的回弹值袁效果较好遥 关键词院岩芯曰回弹仪曰测试方法曰回弹值 文献标志码院A 文章编号院1674-5124渊2017冤09-0035-07 Schmidt hammer test methods for rock core YUAN Guangxiang袁 WANG Pengjiao袁 LI Jianyong袁 HUANG Zhiquan袁 ZHAO Fei 渊School of Resources and Environment袁North China University of Water Resources and Electric Power袁 Zhengzhou 450045袁China冤 Abstract: In order to quickly determine the rock core strength by using Schmidt hammer袁 a new Schmidt hammer test method for rock core was studied according to the principle of Schmidt hammer and core爷s characteristics. When selecting Schmidt hammer model袁 L-type was appropriate袁 and the best is 0.735J. In order to ensure that the Schmidt hammer vertically impact the core surface without rebound in the impact process袁 the auxiliary device should be used袁 including the steel base and the guide pipe. Measuring points were uniformly distributed on circumference of a certain cross section with interval of 90毅 and each measuring point was hammered for one time and the rebound values were recorded. Vertically downward hammering was carried out during rock core rebound test袁 thus rebound value should be corrected袁 and t