美国公路与运输协会标准 AASHTO T315-02 DSR试验方法.pdfVIP

Chapter 7: Standard Test Method for Determining the Rheological Properties of Asphalt Binder Using a DSR Chapter 7: Standard Test Method for Determining the Rheological Properties of Asphalt Binder Using a Dynamic Shear Rheometer (AASHTO T315-02) This column contains excerpts from AASHTO This column contains comments on the equipment and Designation: T315-02 – Standard Test Method for test procedures. Numbers in parenthesis given in headers Determining the Rheological Properties of Asphalt below refer to section numbers in AASHTO T315-02. Binder Using a Dynamic Shear Rheometer (DSR). ___________________________________________ ___________________________________________ A. Principle of Operation 1. Scope DSR is the acronym for Dynamic Shear Rheometer. Dynamic comes from the fact that the stresses or strains 1.1 This test method covers the determination of the applied to the sample vary with time in a sinusoidal dynamic shear modulus and phase angle of asphalt fashion - they are not static. During the test, the asphalt binder when tested in dynamic (oscillatory) shear binder sample is sheared between two parallel plates. using parallel plate test geometry. It is applicable to The DSR equipment used in asphalt binder asphalt binders having dynamic shear modulus values characterization can be divided into two categories: in the range from 100 Pa to 10 MPa. contro