ansys中阻尼的设置.pdfVIP

ANSYS/LS-DYNA 中阻尼的设置 ANSYS/LS-DYNA 中阻尼的设置总结如下： EDDAMP, PART, LCID, VALDMP (用此命令流来定义阻尼) Defines mass weighted (Alpha) or stiffness weighted (Beta) damping for an explicit dynamics model. （默认有质量阻尼与刚度阻尼两种） 图1 LS-DYNA 中的阻尼选项 PART PART number [EDPART] identifying the group of elements to which damping should be applied. If PART = ALL (default), damping is applied to the entire model. （定义施加阻尼的Part 号，如果Part =ALL (or blank)，整体质量阻 尼将被应用于整个模型。） LCID Load curve ID (previously defined with the EDCURVE command) identifying the damping coefficient versus time curve. If time-dependent damping is defined, an LCID is required. （用来指定相对于时间的质量阻尼） VALDMP Constant system damping coefficient or a scale factor applied to the curve defining damping coefficient versus time. （可以用来代替对时间的质量阻尼 曲线，或者使用LCID 命令中的比例系数） 注意： Mass-weighted (Alpha) or stiffness-weighted (Beta) damping can be defined with the EDDAMP command. Generally, stiffness proportional or beta damping is effective for oscillatory motion at high frequencies. This type of damping is orthogonal to rigid body motion and so will not damp out rigid body motion. On the other hand, mass proportional or alpha damping is more effective for low frequencies and will damp out rigid body motion. The different possibilities are described below: 1.Global Damping Mass-weighted or Alpha damping （质量阻尼） When PART = (blank) or ALL (default), mass-weighted global damping can be defined in the following 2 ways. In this case, the same damping is applied for the entire structure. 1. When the damping coefficient versus time curve (LCID) is specified using the EDCURVE command, VALDMP is ignored by LS-DYNA (although it is wr