船体强力构件开孔及补强标准.docVIP

Hull mightiness structure penetration and reinforcement standard 总 页 数 13 船体强力构件开孔及补强标准 Hull mightiness structure penetration and reinforcement standard 1 范围 Extension 本标准是以国内外主要船级社规范为依据，并结合本公司实际生产情况及实船应用的经验编制而成。本标准编制引用文件：（CB/T3136-1995）中华人民共和国船舶行业标准 ；（CB/T-4000-2005）中国造船质量标准；（ZJCM03-041-2007）浙江造船有限公司船舶建造质量标准。 This standard is based on criterions of main bureaus of shipping in the world，also take our actual production and the experiences of our appliance on real ships. The referred documents when compiling this standard are:（CB/T3136-1995）Chinese Shipbuilding Standard; （CB/T-4000-2005）China Shipbuilding Quality Standard; （ZJCM03-041-2007）ZheJiang Shipbuilding Co.Ltd Shipbuilding Quality Standard. 本标准规定了船体强力构件上的区域分类，开孔及补强。 This standard specified classification, penetration and reinforcement of hull structure. 本标准适用于管系、电缆穿过船体强力构件时的开孔及补强。 This standard is applicable to the penetration and reinforcement of hull mightiness structure when pipe system and cable through it. 2 船体强力构件上的区域分类 Space classification of hull mightiness structure 2.1 船体强力构件上的区域分类见表1 As following table 1 表1 区域分类 Table 1 Space classification standard 2.2 横向构件上的区域划分按图1 Space division of transverse member as following picture 1 a. 强横梁 b. 横梁穿过纵桁 a. strong beam b. the beam through longitudinal girder 图1 横向构件上的区域划分 Fig.1 Space division of transverse member 2.2.1 决定B 区域方法见图2。 The way to decide space B is as following picture 2. a. 定O、A点； Fix point O, A. b. ∠OAB不大于45度时取C 点，∠OAB 大于45度时取B 点； ∠OAB less than 45 degree choose point C，∠OAB more 45 degree choose point B. c. 按∠OBE或∠OCE’等于45度来定E 或E’。 Postulate that ∠OBE or ∠OCE is 45 degree to decide E or E’. standard 图2 决定B 区域方法 Fig.2 The way to decide space B 2.3 纵强度构件的区域划分见图3。 Space division of longitudinal member is as following picture 3. a. 纵骨 b. 纵向非水密舱壁板 c. 纵向桁材 a. longitudinal frame b. non-watertight longitudinal bulkhead c. longitudinal girder 图3 纵强度构件的区域划分 Fig.3 Space division of longitudinal member 2.4 平板龙骨上部肋板的区域划分见图4，α取值按2.2.1。 Space division