《某淀粉厂工业污水处理厂工艺设计》-毕业设计(论文).docVIP

摘 要 本次设计主要为某淀粉厂工业污水处理厂工艺设计。根据淀粉工业污水有机物质、悬浮物含量高且处理出水水质要求去除率高的特点，本设计采用厌氧-好氧处理路线。废水首先通过厌氧处理装置，大大去除进水有机负荷，获得沼气，并使出水达到好氧处理可接受的浓度，再进行好氧处理后达标排放。该工艺污水处理流程为：格栅→沉砂池→ABR→SBR→消毒池→出水，污泥处理流程为：剩余污泥→污泥浓缩池→污泥脱水房→泥饼外运。通过此工艺的处理，出水水质将达到《淀粉工业水污染物排放标准》（GB25461-2010）中的排放标准。 本设计要求达到初步设计阶段，设计中对整个处理流程的各构筑物均进行了详细的设计说明和计算，绘制了各单体构筑物的结构图。同时依据设计规范，结合污水处理厂所在地区的地形、风向，对该厂进行了平面布置和高程设计，绘制了平面布置图及高程图。最后根据所采取的工艺，对工程投资及运行费用进行了估算，并编制了该工程的初步设计说明书。 关键词：淀粉工业废水；厌氧-好氧工艺；ABR；SBR； ABSTRACT The design is primarily a starch factory industrial wastewater treatment plant process design. According to the starch wastewater has the characteristics of high organic matter and suspended solids, and the high removal efficiency of effluent quality, this design uses anaerobic - aerobic treatment process. First, the wastewater through anaerobic treatment plant, removal of the influent organic load to obtain biogas and effluent can meet the acceptable concentration of aerobic treatment, then the water can reach the standard of discharge after aerobic treatment. The process of sewage treatment process as follows: grill→the grit chamber →ABR→SBR→the disinfecting tank→water, Sludge treatment process: excess sludge → sludge thickener → sludge dewatering house → cake Sinotrans. After the advanced treatment, the values of the indexes completely reach the standard of Discharge standard of water pollutants for starch industry The design is supposed to reach the stage of principium. And in this design the introduction and calculation of all the structures in detail are made,and the?frame charts of all treatment structures in the process are drawn. At the same time, the design of layout and elevation of the reclaimed water plant is done according to the design specifications, the landform, and wind direction?of the district that the plant is located, and then the drawings of plane and elevation are made. Based on the main process applied, the estimations of engineering investment and operation cost are made. Finally, the introducti