class A检查(通用标准).docVIP

Common Standards for CLASS A Math Data Release Definition of Class-A Surface Aesthetically approved math data from Design Center that honors all known Engineering, Manufacturing Assembly and Human Factors Criteria and also meets all Die Engineering or Tool Source Requirements. Contents of this Document This document attempts to quantify the tolerance and accuracy needed to ensure all math data releases meet the required standards. It also provides recommended practices on how to meet the goals of the DESIGN QUALITY AUDIT prior to release from Design Center. A Class A release is the culmination of many essential components being factored into the Math Data. A component that satisfies all surface quality guidelines yet violates key Manufacturing or Human Factors needs, will not satisfy the Math Audit. The released data should meet the requirements of all the following topics. ?Math Data Tolerances Design Center Deliverables ?Internal Surface Quality ?Surface Continuity Quality ?Fillet Flow Paths ?Surface/Part Harmony and Part Interface Considerations ?Engineering /Manufacturing Criteria Compliance ?Engineering /Manufacturing Die Pull Compliance ?Design, Quality and Verification Audit ?Criteria Checklists Tolerances and Math Data Release Standards Modeling Tolerances ?Using a modeling distance tolerance of 0.01 mm and an angular tolerance of 0.5 degree will help meet the release requirements for adjacent surfaces. ?Using tighter tolerances is allowable but may not be necessary to meet the release standards below. Release Standards for Math Data (UDR and VDR ?All math releases will be provided as UG part files ?Math data can be provided as a solid or surface model ?All exterior data will meet 0.025mm distance tolerance and 0.50 degree tangency (see exceptions NOTE below ?All interior data will meet 0.025mm and 1.0 degree tangency (see exceptions NOTE below Reference NOA #033 for additional guidelines on release data for Alpha2, UDR and VDR Reference NOA #052 for Exa