中级车工考试题.docVIP

中级车工考试题 Mid-level car test (including answers) One point, 25 points? Worm and worm gear is used to transfer the transmission of two shafts of 60 degrees? When the turning module is less than 5MM, the method of cutting and cutting can be used? In order to prevent the three cutting edges from being cut at the same time, it can be used to cut the cutting edge? The distanee between the eccentric parts and the two busines is called the eccentricity〃? The amount of cutting should not be too large when the turning center is eccentric? A percentage of 1OMM in full range is not allowed to measure eccen