清洗炮筒螺杆的方法.pptVIP

SONY PPMT32寸 1500T炮筒螺杆料车改善 报告人：黄敏久 报告日期：2009/4/27 Suzhou Injelic Plastic Co.,Ltd. Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 问题点描述 PPMT32寸面框：产品表面白点和亮点问题； 白点为原料问题（这里我们不再分析）， 因此，我们只对亮点问题进行分析： Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 螺杆料筒拆卸之前原状 料筒状态OK 螺杆状态OK Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 螺杆料筒拆卸之前原状 缸头盖有擦伤 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 原因分析 为适应今年高光薄壁产品的需要，经分析确定：把原直径140MM的螺杆料筒，更换为直径105MM的螺杆料筒， 并于09年01月份开始更换使用至今， 由于螺杆和料筒 长度配合不准确，造成螺杆顶端和料筒缸头盖在注射到零位时，有磨擦现象，造成有少量金属脱 落。 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 对策 1、重新测量螺杆料筒的配合间隙； 2、更换损伤部件； Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 更换后状态 缸头盖更换后状态 螺杆更换后状态 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd.