c506-98中文版-钢筋混凝土制拱形涵洞、排水沟和下水道的标准规范.docVIP

C 506 PAGE 342 Designation: C 506 - 98编号：C 506 - 98 PAGE 335 Standard Specification forReinforced Concrete Arch Culvert, Storm Drain, and Sewer Pipe This specification is under the jurisdiction of ASTM Committee C-13 on Concrete Pipe and is the direct responsibility of Subcommittee C13.02 on Reinforced Sewer and Culvert Pipe.本试验方法归ASTM负责混凝土管道的C-13委员会管辖，并由C13.02试验方法分委会直接负责。Current edition approved Aug. 10, 1998. Published February 1999. Originally published as C 506 - 63 T. Last previous edition C 506 - 95a.现行版本于1998年8月10日批准，并于1999年2月出版。最初以C 506 – 63 T编号出版。上一版本编号为C 506 – 95a。钢筋混凝土 This specification is under the jurisdiction of ASTM Committee C-13 on Concrete Pipe and is the direct responsibility of Subcommittee C13.02 on Reinforced Sewer and Culvert Pipe.本试验方法归ASTM负责混凝土管道的C-13委员会管辖，并由C13.02试验方法分委会直接负责。Current edition approved Aug. 10, 1998. Published February 1999. Originally published as C 506 - 63 T. Last previous edition C 506 - 95a.现行版本于1998年8月10日批准，并于1999年2月出版。最初以C 506 – 63 T编号出版。上一版本编号为C 506 – 95a。 This standard is issued under the fixed designation C 506; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last re-approval. A superscript epsilon (ε) indicates an editorial change since the last revision or re-approval.本标准以固定编号C 506刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后所作的编辑性修改。 This standard has been approved for use by agencies of the Department of Defense.本标准已获得批准供（美国）国防部各部门使用。 1. Scope适用范围 This specification covers reinforced arch-shaped concrete pipe to be used for the conveyance of sewage, industrial wastes, storm water, and for the construction of culverts.本标准规范涵盖用于输送污水、工业废料和雨水的拱形钢筋混凝土管道及涵洞结构。 A complete metric companion to Specification C 506 has been developed—C 506M; therefore, no metric equivalents are presented in this specification.已编制与本规范配套的公制规范——C 506M，因此本规