c315-98b中文版-粘土烟道内衬用标准规范.docVIP

C 315 Designation: C 315 – 98b编号：C 315 – 98b Standard Specification for Clay Flue Linings This specification is under the jurisdiction of ASTM Committee C-4 on Vitrified Clay Pipe and is the direct responsibility of Subcommittee C04.20 on Methods of Test and Specifications.该标准归ASTM负责釉面陶土管的C-4委员会管辖，并由负责标准试验方法和规范的C04.20小组委员会直接负责。Current edition approved Sept. 10, 1998. Published March 1999. Originally This specification is under the jurisdiction of ASTM Committee C-4 on Vitrified Clay Pipe and is the direct responsibility of Subcommittee C04.20 on Methods of Test and Specifications.该标准归ASTM负责釉面陶土管的C-4委员会管辖，并由负责标准试验方法和规范的C04.20小组委员会直接负责。Current edition approved Sept. 10, 1998. Published March 1999. Originally published as C315-53. Last previous edition C315-98a.现行版本于1998年9月10日批准，并于1999年3月出版。最初版本编号为C315-53，上一版本编号为C 315-98a。 This standard is issued under the fixed designation C 315; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C315刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 This standard has been approved for use by agencies of the Department of Defense.该标准已经批准被美国国防部机构使用。 1. Scope适用范围 1.1 This specification establishes the criteria for acceptance, prior to installation, of clay flue linings used for conveying hot gases in masonry chimneys.本标准建立了安装前砌体烟囱中传送热气用粘土烟道内衬的验收标准。 1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.用英寸-磅等单位表示的值为标准值，括弧内给出的值仅供参考。 2. Referenced Documents参考文件 2.1 ASTM Standards: ASTM标准： C 67砖块和结构用粘土瓦抽样和试验用标准试验方法2C 67 Test Methods of Sampling and Testing Brick and Structural Clay Tile Annual Book of ASTM Standards, Vol 04.05. ASTM标准年鉴第04.05卷。 C 301釉面陶土管试验用标