c361-98中文版-钢筋混凝土低水头压力管的标准规范.doc

C 361 page 179 Designation: C361 – 98编号：C361 – 98 page 178 Standard Specification for Reinforced Concrete Low-Head Pressure Pipe1钢筋混凝土低水头压力管的标准规范 This specification is under the jurisdiction of ASTM Committee C-13 on This specification is under the jurisdiction of ASTM Committee C-13 on Concrete Pipe and is the direct responsibility of Subcommittee C13.04 on Low Head Pressure Pipe.本规范归ASTM负责混凝土管的C-13委员会管辖，并由C 13.04低水头压力管分委会直接负责。Current edition approved July 10, 1998. Published March 1999. Originally published as C 361 - 55 T. Last previous edition C 361 - 96.现行版本于1998年7月10日批准，并于1999年出版。最初出版编号为C361 – 55T This standard is issued under the fixed designation C 361; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C 361 M刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 This standard has been approved for use by agencies of the Department of Defense.本标准已获得批准供（美国）国防部各部门使用。 1. Scope适用范围 1.1 This specification covers reinforced concrete pipe in tended to be used for the construction of pressure pipelines with low internal hydrostatic heads generally not exceeding 125 ft.本规范涵盖用于内部静水低压头通常不超过125英尺的压力管路施工的钢筋混凝土管。 1.2 A complete metric companion to Specification C 361 has been developed—C 361M; therefore, no metric equivalents are presented in this specification.已编制与规范C 361配套的完整公制规范C 361M，因此本规范中没有列出公英制对照表 Note 1—Field tests on completed portions of the pipeline are not covered by this specification for the manufacture of the pipe but should be included in specifications for pipe laying.注1——有关管道制造的本规范中没有包括管路已完工部分的现场试验，但应包括在管道铺设相关规范中。 2. Referenced Documents参考文件 2.1 ASTM Standards: ASTM标准： A 27/A 27M Specification for Steel Castings, Carbon, for General Application 2A 27/A 27