hpsmartstorageadministrator扩容阵列的方法.pdfVIP

HP Smart Storage Administrator – 扩容阵列的方法 By Ju,zhen-wen 05/15/2014 目录 实验环境：1 进入 SSA: 1 Add drive 增加驱动器 Expand Array 扩容阵列 10 Move drive 移动阵列11 Mirrir array 镜像阵列 11 Shrink Array 收缩阵列 12 Replace Array 更换阵列13 实验环境： 机型: DL380p Gen8 IP 版本: 1.5 以上 进入 SSA: 服务器自检时，通 F10 进入 IP，并按下图选择：Perform Maintenance 进入 Hp smart storage administrator。（SSA） 如下图： 进入 SSA 后第一个界面如下图： 选择：configure 在当前界面看到一块硬盘做的 raid 0。Unassigned drives 有 2 个. 确认缓存 cache 和电容 capacitor ，点击右下角 view more details。 看到了 cache 大小 1024MB,电容的数量为 1 Close 之前界面，在主界面点击 manage data drives. 可以看到如下 3 个选项： Expand Array 扩容阵列 Increase the capacity of an existing array by adding currently existing unassigned drives to it.Note: Only physical drives of the same size (within 10 percent) should be added to the same array because all the drives within an array are reduced to the size of the smallest physical drive. For example, an array with three 300 GB drives and a 750 GB drive would be viewed as being the same size as an array with four 300 GB drives since the 750 GB drive is seen as a 300 GB drive.Expand array has the following options:Expansion TypeFor arrays that contain RAID 50 or RAID 60 logical drives, array expansion is constrained by the number of drives in the array and the number of parity groups in the existing logical drives. The transformation type refers to the different methods that apply to these logical drives: Increase Number of Parity Groups: the required number of physical drives will be added to form new parity group(s) for the array.Increase Number of Drives in Each Parity Groups: the required number of physical drives will be added evenly to each existing parity group.The notes on the top of the page will tell you how many drives are needed for each transfo