钢管混凝土截面(施工联合截面)的实践.docVIP

MIDAS哑铃型截面的实践 WeiJunZiLang CP1.0 Midas哑铃型钢管混凝土截面(施工联合截面)的实现 目 录 一、前言......................................................................................................................................................2 二、Midas组合截面的计算原理 ................................................................................................................2 三、为什么要采用MIDAS的施工阶段联合截面的功能 ............................................................................2 四、采用施工阶段联合截面必须要做的操作 ..........................................................................................2 五、建立施工阶段联合截面的几种方法 ..................................................................................................3 六、采用一般截面联合形式建立哑铃型截面的步骤 ..............................................................................4 6.1建立dxf文件并导入SPC................................................................................................................4 6.1.1 CAD曲线导入后分割 ........................................................................................................5 6.1.2 CAD直接采用多段线 ........................................................................................................5 6.1.3 CAD中两个半圆拟合整圆 ................................................................................................5 6.1.4 采用Line法生成截面 ......................................................................................................5 6.1.5 上述四种生成截面方法结果的比较 ..............................................................................6 6.1.6 Plane法和Line的选用 ....................................................................................................6 6.2定义组合截面材料参数 ................................................................................................................7 6.3定义组合截面总体参数 ................................................................................................................7 6.4分别定义组合截面的各子截面 .........................................................................................