ASME SEC II C SFA-5.21-2004 标准规范下载.pdf

SPECIFICATION FOR BARE ELECTRODES AND RODS FOR SURFACING SFA-5.21 (Identical with AWS Specification AWS A5.21:2001) 1. Scope ASTM B 214, Test Method for Sieve Analysis for Gran- 1.1 This specification prescribes the requirements for ular Metal Powder the classification of bare electrodes and rods for surfacing. ASTM A 285/A 285M, Specification for Pressure Ves- The specification does not provide for classification of sel Plates, Carbon Steel, Low and Intermediate Tensile electrode-flux combinations for submerged arc welding. Strength ASTM DS-56/SAE HS-1086, Unified Numbering Sys- 1.2 Safety and health issues and concerns are beyond tem for Metals and Alloys the scope of this standard and, therefore, are not fully addressed herein. Some safety and health information can 3. Classification be found in the Annex sections A5 and A10. Safety 3.1 The surfacing electrodes and rods covered by this and health information is available from other sources, specification are classified according to the following: including, but not limited to, A